Creatio goes zoneless in 10.2.1: is your custom code ready?

Hi everyone!

Starting with Creatio 10.2.1, Freedom UI will run in zoneless change detection mode by default. Creatio will no longer load zone.js and will refresh the UI only when the displayed data changes, so pages open faster and front-end errors are easier to trace.

Most custom code keeps working as is. Your code might need changes if it:

  • starts asynchronous work in a "Client module" request handler without await;
  • reads zone.js internal fields, such as __zone_symbol__value;
  • is a remote module that relies on zone.js.

You don't have to wait for 10.2.1 to prepare:

  1. Now: check your code against the migration guide and apply the fixes. They work with zone.js too.
  2. When Creatio 10.2 is released: turn on the EnableZoneless additional feature in a non-production environment and test your customizations.

👉 Read the full migration guide: Migrate custom code to zoneless change detection

Have questions or a case the article doesn't cover? Ask in the comments below.

Like 2

Like

Share

4 comments

Thanks for the info, it's great that we're being warned about this a good time ahead of the change & being alerted via Community posts.

 

Could the linked article be updated to expand on some of these points though:

 

E.g. I'm not too sure what is meant by code after the first await operator in a request handler not being waited for in either mode - does this mean that we should be structuring code in some special way so that the first await call is awaiting any/all important async events? Such as lining up a number of async calls and then doing an await Promise.all() on all of them? And should have been doing this all along, given it says this behaviour is consistent between the current and zoneless modes? It would be good to get some other examples of code that is fine in both modes for the scenarios mentioned to add some clarity.

 

Could you also clarify whether this is coming as the default in 10.1.2 or 10.2.X as this post says one while the article mentions others.

Hi Yan, 

Do you have a timeline for when we need to be ready for ?

Thanks, 

Damien

 

Damien Collot,

Hi Damien,

Sorry for the confusion with the versions - we had to rethink versioning for the upcoming releases.

Zoneless will be available in 10.2 (Dec 2026 - Jan 2027)
Zoneless with be enabled in 10.2.1 (approximately Feb 2027)

Harvey Adcock,

Hi Harvey,

Sorry for the confusion with the versions - we had to rethink versioning for the upcoming releases.

Zoneless will be available in 10.2 (Dec 2026 - Jan 2027)
Zoneless with be enabled in 10.2.1 (approximately Feb 2027)

I will also discuss questions with the dev team about the article and get back with feedback.

Show all comments